| Opening
Height:
measure the opening height at both ends and in the centre of the
opening (usually from the top of your floor
covering to the ceiling, allowing for carpet ,etc), take the smallest measurement as the opening height
Opening Width:
measure the
opening width at the top and the bottom of the opening, take the
smallest measurement as the opening
width
please note that the track set will be supplied slightly longer than
the opening width to allow for accurate cutting on site
End panel:
an end
panel is typically used to form the end of the wardrobe when the
doors are not going up to a wall.
If using an end panel the opening width would be from the
inside of the end panel to the wall, or if using two end panels the
opening width would be between the end panels
end panels are 2620mm high x 640mm wide x 18mm thick
and you can cut them to fit.
Strike Plates:
strike plates can be used where the doors butt up to a wall to
even out any irregularities in the wall, the strike plate can either
be cut to fit above the skirting board or the skirting board can be
cut out to allow the strike plate to fit from floor to ceiling
if using strike plates the opening width would be between
the strike plates e.g. if you have measured wall to wall and you are
using two strike plates you would deduct 36mm
each strike plate is 2620mm high x 100mm wide x 18mm thick
and you can cut them to fit
|
