Columns

1. Using the 2mm Allen key supplied slacken the retaining screw in the fixing plate attached to the top of the long section. Slot the short horizontal section onto the fixing plate and tighten the retaining screw.

2. Drill the wall using an 8 mm diameter drill and insert wall plugs.

3. Screw the columns to the wall with the screws provided and ensure they are level and plumb, use the adjuster foot as required. Note: The foot can just rest on the floor or you can screw the small plastic foot button to the floor and sit the foot over the button - this method is preferred when fitting to a hard floor surface but not usually required if the column is sat on carpet.

Shelves:

1. Slacken the retaining screw on the face of the shelf bracket and insert the bracket into the slot in the column and tighten the fixing screw using the 4mm Allen key provided. Ensure brackets are in the approximate position required.

2. Slacken the screw on the bottom of the bracket and lift the top part of the clamp up, slot the shelf into the clamp and then tighten the screw to secure the shelf.

Hanging rail:

1. Slacken both the retaining screws on the hanging rail brackets using the 2mm and 4mm Allen keys provided.  Insert the brackets onto the ends of the hanging rail.

2. Insert one end of the hanging rail into the slot in the column at approximately the required height and with the hanging rail sloping up at an angle gently insert the other end into the next column. Tighten the large retaining screws to connect the bracket to the column and then tighten the small screws which lock the bracket to the hanging rail.

If you require further assistance, please call 01423 505246 (Mon-Fri 9.00 am – 5.00pm)